High Performance Factory Activated
Motorcycle Battery
Key Features of Our High Performance Factory Activated
- When under -18℃ temperature environment, the battery keeps a high CCA value and has excellent low temperature performance of high current discharge, and it even remains the starting performance at 40°C low temperature.
- Complete new structural design, and minimum the internal resistance and maximized the plate electrochemical reaction area.
- The battery active substance adopted special organic additives which slower down the passivation of the negative plate and improve the effective specific surface area of the active material.
- The grids are made of multiple lead alloy, which enhances the corrosion resistance and prolongs the battery life.
- Higher output capacity, charging capacity and charging efficiency at low temperature.
- The cycle life of high rate discharge and low DOD is long.
OUTDO
Characteristic of High Performance Factory Activated
High Performance Valve Regulated Factory Activated Lead Acid Battery is suitable for motorcycle starting and all kinds of electrical equipment requiring batteries to provide large current instantaneously in a variety of ambient temperatures, especially in the extremely low temperature.
Factory Activated Safe Use Precautions
I. Warning
- The electrolyte inside the battery is corrosive and may damage metal, cotton products, and stone. Handle the battery properly.
- Do NOT place the battery on its side or upside down to prevent acid leakage.
- Hydrogen gas may be generated during battery operation and charging. If exposed to fire or sparks, it may cause an explosion. Please observe the following precautions:
- Use and maintain the battery in a well-ventilated area.
- Keep sparks and open flames away during battery maintenance.
- If the battery is charged outside the vehicle, do not install it immediately after charging. Let it rest for at least 10 minutes to allow hydrogen gas to dissipate.
- After riding, do not remove the battery immediately. Let it rest for at least 10 minutes.
- During charging, the ambient temperature should not exceed 45°C. If it does, cool the battery with water or reduce the charging current and voltage.
- Do NOT place metal tools or conductive materials near the terminals to avoid short-circuiting.
- Do NOT strike the terminals with a hammer during battery installation.
- Handle the battery carefully during transportation to avoid impact or damage.
II. Factory Activated Installation and Maintenance
- Connect the positive terminal first. Do NOT reverse the polarity, otherwise the motorcycle’s electrical equipment may be damaged.
- Activation Notice:
- Some batteries may not be activated immediately due to differences in vehicle performance. Start the engine several times or gently apply the throttle to help activate the battery more easily.
- Manual activation is recommended to ensure the exact activation date is recorded.
- During acid filling, wear acid-resistant clothing, rubber boots, safety goggles, and rubber gloves. If acid splashes onto skin or clothing, rinse immediately with a large amount of water. Seek medical attention if necessary.
- Do NOT over-discharge the battery. Recharge the battery promptly after it has been discharged.
- Disconnect the negative terminal if the motorcycle will not be used for a long period.
- Do NOT check whether the battery has power by short-circuiting the terminals.
- Regularly check the terminal connections and ensure the terminals are clean to maintain good contact.
- Store the battery in a dry, well-ventilated place at 5–25°C, away from direct sunlight. Keep the battery at least 2 meters away from heat sources. Check and maintain the battery regularly.
Related Products
| Series | Model | Voltage (V) | Capacity (Ah) | Hour Rate (HR) | Dimensions±2 (mm) | Polarity | Weight±3% (KG) | Terminal | Regular Charge Current (A) | Meter CCA (25±5°C) | CCA (-18°C) | Datasheet |
|---|---|---|---|---|---|---|---|---|---|---|---|---|
| Factory Activated | HC12A-MF | 12 | 10 | 10 | 150*86*104 | + - | 3.65 | Z4 | 1 | 370 | 190 | |
| Factory Activated | HCX7L-MF | 12 | 7.5 | 10 | 113*70*130 | - + | 2.65 | Z3 | 0.75 | 190 | 120 | |
| Factory Activated | HCX8L-MF | 12 | 9 | 10 | 113*70*130 | - + | 2.87 | Z3 | 0.9 | 260 | 140 | |
| Factory Activated | HCX12-MF | 12 | 12 | 10 | 150*86*130 | + - | 4.15 | C12 | 1.2 | 320 | 190 | |
| Factory Activated | HCX14-MF | 12 | 14 | 10 | 150*86*145 | + - | 4.78 | C12 | 1.4 | 310 | 210 | |
| Factory Activated | HCX14L-MF | 12 | 14 | 10 | 150*86*145 | - + | 4.78 | C12 | 1.4 | 310 | 210 | |
| Factory Activated | HCX16-MF | 12 | 16 | 10 | 150*86*161 | + - | 5.45 | C12 | 1.6 | 350 | 240 | |
| Factory Activated | HCX16L-MF | 12 | 16 | 10 | 150*86*161 | - + | 5.45 | C12 | 1.6 | 350 | 240 | |
| Factory Activated | HCX24L-MF | 12 | 24 | 10 | 205*91*161 | - + | 7.42 | C13 | 2.4 | 400 | 350 | |
| Factory Activated | HCX30HL-MF | 12 | 32 | 10 | 166*127*175 | - + | 9.52 | C13 | 3.2 | 480 | 400 | |
| Factory Activated | HCX30L-MF | 12 | 30 | 10 | 166*127*175 | - + | 9.1 | C13 | 3 | 440 | 350 | |
| Factory Activated | HCZ5D-MF | 12 | 5 | 10 | 113*70*85 | - + | 1.64 | Z3 | 0.5 | 160 | 65 | |
| Factory Activated | HCZ5S-MF | 12 | 5 | 10 | 113*70*85 | - + | 1.69 | Z3 | 0.5 | 190 | 80 | |
| Factory Activated | HCZ7D-MF | 12 | 6 | 10 | 113*70*105 | - + | 2.16 | Z3 | 0.6 | 190 | 100 | |
| Factory Activated | HCZ7S-MF | 12 | 6 | 10 | 113*70*105 | - + | 2.2 | Z3 | 0.6 | 220 | 110 | |
| Factory Activated | HCZ10S-MF | 12 | 9 | 10 | 150*86*93 | + - | 3.14 | Z4 | 0.9 | 320 | 170 | |
| Factory Activated | HCZ12S-MF | 12 | 11.2 | 10 | 150*86*110 | + - | 3.63 | C12 | 1.12 | 320 | 190 | |
| Factory Activated | HCZ14S-MF | 12 | 12 | 10 | 150*86*110 | + - | 3.9 | Z4 | 1.2 | 380 | 210 | |
| Factory Activated | HCZ20-MF | 12 | 20 | 10 | 177*88*155 | + - | 6.2 | C13 | 2 | 450 | 270 | |
| Factory Activated | HCZ20H-MF | 12 | 20 | 10 | 177*88*155 | + - | 6.46 | C13 | 2 | 490 | 310 | |
| Factory Activated | HCZ20HL-MF | 12 | 20 | 10 | 177*88*155 | - + | 6.46 | C13 | 2 | 490 | 310 | |
| Factory Activated | HCZ20L-MF | 12 | 20 | 10 | 177*88*155 | - + | 6.2 | C13 | 2 | 450 | 270 |